Table of Contents
Advertisement
2.4
Quick Start of UBC-220
2.4.1
Debug Port Connection
1.
Connect debug port cable to the UBC-220 debug port.
2.
Connect the RS-232 extension cable to the debug cable.
3.
Connector the other side of the extension cable to the USB-to-RS-232 cable
then connect to your PC.
2.4.2
Debug Port setting
UBC-220 can communicate with a host server (Windows or Linux) by using serial
cables. Common serial communication programs such as Hyper Terminal, Tera Term
or PuTTY can be used in this case. The example below describes the serial terminal
setup using Hyper Terminal on a Windows host:
1.
Connect UBC-220 with your Windows PC by using a serial cable.
2.
Open Hyper Terminal on your Windows PC, and select the settings as shown in
Figure 3.6.
3.
After the bootloader is programmed on SD card, insert power adapter connector
to DC jack on UBC-220 to power up the board. The bootloader prompt is dis-
played on the terminal screen.
Figure 2.21 Drawing of mating screw
Figure 2.22 Mating screws for wall mounting
19
UBC-220 User Manual
Advertisement
Table of Contents
