Advertisement
Features and Controls
Reverse the steps above to install the
T-top panels.
When installing panels, be sure to align
weatherstrips properly. Panels incorrectly
installed may leak.
NOTICE:
High pressure car washes may cause
water to enter your vehicle. Never
spray water directly at the roof panel
joints. This will cause leaks.
r-Top Sunshades
I .
2.
Start with the panel marked "DRIVEE
FRONT." Unlatch the driver-side
T-top, raise it halfway and close the
latch handle.
With the top raised and resting on the
center toof rail, slide the flat edge of
the sunshade panel (with the vinyl
side to the glass) between the glass
and plastic trim, making sure the
edge marked "DRIVER FRONT." is
pointing to the front of the vehicle.
3.
4.
Open the latch and close the T-top.
Check to see if there are any gaps
showing. Unlatch the T-top and
adjust the sunshade as required.
Once the sunshade is installed
properly, you can stick the Velcro@
buttons on the glass for a proper fit
every time you install the sunshades.
To do this, first remove the T-top
with the sunshade installed and place
it upside down on a table or bench.
Take care not to scratch the glass.
..A2
Advertisement
