Advertisement
Shutting Off the Theft-Deterrent
Feature
If your audio system is secured ("SEC"
shows on display) and you wish to disable
it, enter your security code as follows,
pausing no more than 15 seconds between
steps:
1. Turn the ignition on. Make sure the
audio system is off. The time will
show
on
the display.
together until "SEC" shows on the
display.
3.
Press "MIN." "Oi>O,' will appear on
the display.
4. Press "MIN' again and hold until the
last two digits of your code appear.
Release the button.
5. Press "HR' until the first one or two
digits of your code appear.
6. Press "AM/FM." If
"---"
shows, you
have shut off the theft-deterrent
feature. If "SEC" shows, your aud
system is still secured.
NOTE: If you lose or forget your security
code, see your dealer for assistance.
2. Press pushbuttons "1" and "4"
4
Unlocking the Audio System after a
Power Failure
If power is disrupted to the audio system
while in the "SEC" mode, the unit will
not work and "LOC" will show on the
display whenever the ignition is on. To
unlock the unit:
1. Press "MIN."
"000"
will appear on
the display.
2. Press "MIN' again and hold until the
last two digits of your code appear,
Release the button.
3.
Press "HR' until the first one or two
4. Press "AM/FM." "SEC" will appear
digits of your code appear.
on the display and the unit will work.
If "LOC" shows, the numbers did not
match and the unit is still locked.
How to Change Your Security Code
You can change your security code by
following these steps:
1. Using your old code, follow the
directions given under "Shutting Off
the Theft-Deterrent Feature."
2. Repeat directions of "Setfing Your
Security Code" with your new
security code.
Understanding Radio Reception
FM Stereo
FM
stereo will give you the best sound.
But FM signals will reach only about
10 to 40 miles (16 to 65
km).
And, tall
buildings or hills can interfere with
FM signals, causing the sound to come
and go.
AM
The range for most AM stations is greater
than for FM, especially at night. The
longer range, however, can cause stations
to interfere with each other. AM can pick
up noise from things like storms and
power lines. Try reducing the treble to
reduce this noise if you ever get it.
AM Stereo
This means the Delco@ system can
receive C-QUAM@ stereo broadcasts.
Many AM stations around the country
use C-QUAM@ to prodyce stereo, though
some do not. (C-QUAM@
is
a registered
trademark of Motorola, I&) If your
Delco@ system can get C-QUAM@, your
"STEREO" light will come on when
you're receiving it.
121
...
Advertisement
