Service Mode; Outline - Canon SORTER S-82 Service Manual

CHAPTER 4
II. SERVICE MODE
A. Outline
Status LED
Service LED
DIP switches
The sorter has an status LED (LED1: LED PCB), which allows the user to check the condition of
the sorter, and a service LED (LED1: sorter driver PCB), which allows the service technician to
check the operation when a malfunction occurred in the sorter.
changed according to the combination of the DIP switches (SW1) on the sorter driver PCB.
The status LED can indicate the following 3 conditions of the sorter.
1) Green light ON: Normal communication between the sorter and printer.
2) Orange light flashing: Operator intervention is required due to problems like paper jam, door
open, etc.
3) Orange light ON: Failure has occurred.
Note: The status LED is effective only when all of the DIP switches are OFF (as factory-setup).
4 - 4
LED PCB
Figure 4-2-1
Sorter driver PCB
Power supply PCB
Stand alone mode switch
Joint sensor lever
The Service mode can be