Entrance Sensor; Reversing Sensor - Canon SORTER S-82 Service Manual

B. Entrance Sensor
1) Following the removal procedures of the
front and rear covers on Page 3-2,
remove the front and rear covers.
2) Remove the screw
entrance guide cover.
Screw
Entrance guide cover
Figure 3-4-2
3) Disconnect the connector, and then
remove the entrance sensor by unhook-
ing the claw.
Claw

Entrance sensor

Figure 3-4-3
and then the
Connector
C. Reversing Sensor
1) Following the rear cover removal proce-
dure on page 3-2, remove the rear cover.
2) Disconnect the connector.
the sensor lever, remove the screw and
then the reversing sensor holder.
Connector
Screw
Reversing sensor holder
Sensor lever
Figure 3-4-4
3) Unhook the claw, and then remove the
reversing sensor from the reversing sen-
sor holder.
CHAPTER 3
Lifting up
3 - 9