Canon SORTER S-82 Service Manual page 80

CHAPTER 4
Action: Perform the sensor check mode on Page 4-8 to see whether or not the sensor is in
fact defective. Replace the paper sensor PCB if the sensor is found defective.
8. Reversing sensor lever does not move smoothly or is damaged.
Action: Replace the lever if damaged.
replace the reversing sensor (PI10).
9. Defective reversing sensor lever spring
Action: Set the spring in the right position if it is out of place. Replace it if deformed or
damaged.
10. Defective reversing sensor
Action: Perform the sensor check mode on Page 4-8 to see whether or not the sensor is in
fact defective. Replace the sensor if defective.
11. Vertical path sensor lever does not move smoothly or is damaged.
Action: Replace the lever if damaged.
replace the vertical path sensor (PI11).
12. Defective vertical path sensor lever spring
Action: Set the spring in the right position if it is out of place. Replace it if deformed or
damaged.
13. Defective vertical path sensor
Action: Perform the sensor check mode on Page 4-8 to see whether or not the sensor is in
fact defective. Replace the sensor if defective.
14. Defective face-down deflector
Action: Replace the deflector if worn, fractured or scarred.
15. Defective sorter driver PCB
Action: Replace the sorter driver PCB.
4 - 12
If the problem persists after replacing the lever,
If the problem persists after replacing the lever,