Table of Contents
Advertisement
2
Important information
2.1
Compatibility of the impact devices
The impact devices type P and PG also mentioned
in these operating instructions refer to the previous
PAROTESTER - model ( 1 ). These impact devices can
also be used with the PAROTESTER 2 if the impact
device cable has a BNC connection.
2.2
Compatibility of data upload to a PC
Upload of the saved measurement data via RS232 is
possible with the PAROLINK/PAROLINK 3 software,
version 1.X., for all PAROTESTER models.
The special corresponding cable is supplied with the
PAROLINK 3 software.
Upload of the measurement data to a PC without
the PAROLINK 3 software is also possible with the
Windows «Hyperterminal» software.
The special cable is necessary and can be ordered as
an accessory.
© 2012 Proceq SA
2.3
Compatibility with the barcode reader
A barcode reader can only be connected to the serial
interface RS232 of the PAROTESTER 2 display device
from series no. SN. 511.XXXX, Eprom Vers. 5.1
onwards. The barcode reader is supplied with power
from the PAROTESTER 2 display device (battery supply).
2.4
Compatibility with printing of the
measurement data
An RS232 cable, 9 / 9p, wired 1:1 is required from series
SN 511.XXXX, Eprom Vers. 5.1 onwards due to the
multi-purpose serial interface and for printing the data
on a printer with RS232.
2.5
Preventing damage
PAROTESTER2 is designed for rolled paper, films and
foils. Test impact on harder materials damages the
impact body which can produce in incorrect results.
2.6
Correct measurement
- PAROTESTER 2 is a precise measuring instrument
and should also be used as a measuring instrument.
- If the measurement is carried out too quickly, the
impact body is additionally accelerated. This can result
in incorrect measurements. PAROTESTER2 recognizes
the faulty measurement procedure.
Important information
3
Hide quick links:
Advertisement
Table of Contents
