Table of Contents
Advertisement
12.3
Test block U
The test blocks type U are valid for the impact devices
type U, P and PG. Compliance with the engraved values
guarantees the correct function of the impact devices
and the electronic display device PAROTESTER2 over
the entire measurement range.
The test blocks U are calibrated with the reference
Parotester impact devices and marked as follows with
the respective reference values (refer to the example).
Series no.:
U.217.9801 A
Reference vales with set value range for impact devices U,
P, PG:
LU = 588 ± 12
LP = 615 ± 12
When the impact devices U, P, PG are
checked, the test block must be placed
on a flat, solid surface.
12.4.
Printer
The PAROTESTER2 offers the option of printing mea-
sured data on a printer via the RS 232 interface, 9-pin
connector. The portable thermal printer with recharge-
able batteries type DPU - 201 GSE ( paper width: 57 mm )
is recommended as an accessory.
This printer with mains power supply is available with
220 / 110 Volt from Proceq ( www.proceq.com ).
30
Accessories
.
.
LPG = 653 ± 12
Taking into operation
The settings of the printers supplied with
PAROTESTER2 are already set at the works. Printer
settings must be made with the DIP switches. These
are located next to the 9-pin connector. Open the DIP
switch cover. The setting is made once when the printer
is switched off.
The settings on the DIP switches are:
OFF
ON
•
•
•
Switch
1
2
3
Connect the printer and the PAROTESTER2 electronic
system with the printer cable. Switching the printer to the
ON 1 setting means: Printer in operation
- Printer cable «Art. no. 360 04 535» for
PAROTESTER2 from EPROM vers. 5.1
- Printer cable «Art. no. 350 74 994» for
PAROTESTER2 up to EPROM vers. 5.0
Charging the rechargeable printer batteries
- The rechargeable batteries must be charged when the
«BATT.LOW» lamp flashes.
- Connect the mains power supply and the printer.
- Switch the printer to the ON 2 position.
•
•
•
4 5
6
© 2012 Proceq SA
Hide quick links:
Advertisement
Table of Contents
