Installation - Kontron ETXexpress-WPM User Manual

Installation

The following information explains how to set up your ETXe-WPM (ETXexpress-WPM)
and the ETXexpress Carrier Board (ETXexpress Eval Type 3).
1. In an ESD-protected area, remove the ETXexpress Carrier Board and
ETXexpress-WPM from their packaging.
2. If necessary, install memory and a processor on the ETXexpress-WPM.
3. Depending on your application, attach a fan and a heat sink to the ETXexpress
Module if needed.
4. Insert the ETXexpress-WPM into Connector J22 on the Carrier Board and fasten
module to carrier with appropriate hardware.
5. Plug the ATX power supply into a surge protector that is plugged into an
electrical outlet. Make sure that the external Power supply is in the "Off" position.
6. Insert the ATX power cable into Connector J41 on the Carrier Board. Insert the
AUX power (+12V) cable into Connector J42 to power the ETXexpress-WPM.
7. Disable the Carrier Board's BIOS by removing the jumper on Connector J15.
8. Insert a keyboard (bottom connector) and a mouse (top connector) into the PS/2
connectors (J5).
9. On the Carrier Board, plug in a storage device to the appropriate Connector:
SATA (J10, J12, J13 or J14) or USB External Drive.
10. Turn on power.
page 16 ETXexpress-WPM User's Guide