Haulotte Compact 8 Maintenance Book page 51

General data
Pins and bearing inspection
6 - Procedure of reassembly
6.1 - P
INS AND BUSHES
When reassembling bearings and pins ensure that :
• Lightly lubricate the housing into which the bearing is to be installed.
• Insert the bearing using a bearing drift, preferably out of mild steel.
• The bearing, the bearing drift and the bearing housing must be correctly aligned during the assembly
process.
• The recommended values for the bearing drift are given on the diagram below :
Marking
A At least 0,5 times the nominal diameter
B Make a chamfer
C Nominal diameter of the bearing - 0,2 / - 0,3 mm (-7874 µ in / -11810 µ in)
D Bearing drift
E Diameter of the bearing guide - 0,20 / - 0,25 mm (-7874 µ in / -9843 µ in)
F Bearing
G Housing
• After inserting the bearing, lubricate and fit the pin.
4001012670
Recommended Values
A
E
B
E 06.20
MS0002
C
D
F
G
Description
USA / GB 51