Power Button Functions - Honeywell TR80 Installation And Operating Manual

3. 11. 6 Power button functions

For the device's READY mode, the power button can be assigned different functions
Register
type
Holding
Holding
Holding
Input
The power button function is described in the below table.
Value
0
1
2
3
4
5
TR80 is primarily a display, not a control device. Therefore, further settings and some configu-
ration on the master controller or DALI side are required for these functions to work.
Relevant TR80 settings:
• Departure delay: This is a parameter on the TR80 with a default of 10 seconds. When the
power-button press is to activate 'Lights Off' command, the display will count down from
this value before executing the command. This is to ensure the room tenant is not left in the
dark when exiting.
• Scene settings for lights on & off: If a DALI64 sensor is on port 2, the TR80 can turn the lights
on/off directly without involving the master controller. It will do that by sending 'recall scene'
commands to the DALI64 sensor. Therefore, it is necessary to set which scenes numbers are
41
Relative Absolute
Dir
Address Address
2110 42111 R/W
2111 42112 R/W
115 2118 R/W
102 30103 R
Function
No Function
Dark Mode
Sleep Mode
SwitchLightsOnOffToggle
SwitchLightsOn
SwitchLightsOff
Config
Name
parameter
Power
Button
108
Short Press
Function
Power
Button
109
long Press
Function
Departure
42119
delay
Hello/
Goodbye
-
user
command
The power button will not be enabled
The power button activates dark mode.
The power button switches the device to SLEEP mode.
With each tap, the power button toggles 2 scenes, that would typically be
configured to turn the lights on and off.
On every tap, the power button sends scene command, that would typically
be configured to turn the lights on.
On every tap, the power button sends scene command, that would typically
be configured to turn the lights off.
TR80 - Installation and Operation Guide
Type Range
0: No function
1: Dark Mode
2: Sleep Mode
enum 3:SwitchLightsOnOff
Toggle
4: SwitchLights On
5: SwitchLights Off
enum Same as above
secs 0-300 seconds
0: default
1: Lights On command
enum activated
2: Lights Off command
activated
Description
.
Default
value
2
0
10 s