Adjusting Temperature; Changing The Temperature Unit; Adjusting The Fan Speed - Honeywell TR80 Installation And Operating Manual

•
•

2.5 Adjusting Temperature

when the device is unlocked user can change the temperature setpoint value. The
procedure to change the temperature setpoint value is as follows:
1. Tap
Note: If setpoint change is disabled by the controller, then
2. Tap
3. Tap
Note: Tap , to exit without saving the changes and retain the previous set point value. In
case of timeout, it will exit the mode without saving the changes.

2.5.1 Changing The Temperature Unit

The temperature unit can be changed by pressing the temperature key if the device
is in ready mode. Depending on configuration, this may require a long press.
Note: In some configurations, unit change may be disabled. Contact Service engineer to
enable it.

2.6 Adjusting The Fan Speed

Tap
type of fan. Two types of fans are supported by TR80 wall module such as:
20
together with unit and sequence number.
To hold any parameter on display long press ok key for 2 sec.
Tap OK again to return to Operating mode.
, to enter in temperature Setting mode.
The screen shows the currently active setpoint (flashing).
to set desired temperature value.
to save new setpoint value and exit.
to change the fan speed. The settings are slightly different depending on
TR80 - Installation and Operation Guide
are disabled.