2.6.2 EC Fans
In this type of fan setting, display shows FAN in upper display and fan speed along
with unit in larger display. In this fan speed setting is done in terms of percentage
(0 to100%). Refer the figure shown below.
The procedure to do fan speed setting for Speed fan is as follows:
1. Tap
2. Tap
3. After selecting fan speed tap
4. Tap
2.7 Selecting Or Overriding Occupancy status
The wall module provides two type of occupancy modes depending upon the
device configuration such as:
•
•
2.7.1 Simple Occupied/ unoccupied selection
In this mode, occupancy status is determined by the user. The procedure to switch
between Occupied/ unoccupied mode is as follows:
1. Tap
22
in Operation mode, to enter in fan speed Setting mode.
to set, the fan speed in % (from 0 to100%).
to switch between auto /min speed /manual.
Simple Occupied/ unoccupied selection
Advanced Occupancy selection
to switch between Occupied/ unoccupied mode.
The current active occupied/ unoccupied mode is indicated by occupancy sym-
bol on the display.
.
TR80 - Installation and Operation Guide