Power - Honeywell PRO3200 Installation Manual

Installing the PRO3200 Two-Reader Module

Power

The assignment for each relay status LED is shown in the following table.
Table 4: Additional PW6000 Two-Reader Module LEDs
LED number
D3
D4
D5
D6
D7
D8
D9
D10
D11
D12
D13
D14
D15
D16
D17
D18
D19
D20
Power
The Two-Reader Module accepts 12VDC with an operating range of 10 to 14VDC and consumes a
maximum of 650mA of current. Locate power source as close to this board as possible. Connect power
with minimum of 18AWG wire.The input voltage is regulated to 5VDC.The regulated voltage or the
12VDC (pass through) is available for powering the readers. The selection is made via jumpers and is
available at both reader connectors.
6
Description
Reader 0 activity
Reader 1 activity
Input 0
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Tamper
Power
Relay 0 status
Relay 3 status
Relay 2 status
Relay 4 status
Relay 1 status
Relay 5 status
www.honeywell.com