Table of Contents
Advertisement
RS600A
4
Operation
4.1
Preparing the Machine for First Use
Procedure
Perform the procedure below to prepair the machine.
1. Make sure all loose packaging materials have been removed from the machine.
2. Check the machine and its components for damage. If there is visible damage,
do not operate the machine! Contact your Wacker Neuson dealer immediately
for assistance.
3. Take inventory of all items included with the machine and verify that all loose
components and fasteners are accounted for.
4. Attach component parts not already attached.
5. Add fluids as needed and applicable, including fuel, engine oil, and battery acid.
6. Move the machine to its operating location.
4.2
Recommended Fuel
The engine requires regular grade unleaded gasoline. Use only fresh, clean
gasoline. Gasoline containing water or dirt will damage the fuel system. Consult the
engine owner's manual for complete fuel specifications.
Use of
Some conventional gasolines are blended with alcohol. These gasolines are
oxygenated
collectively referred to as oxygenated fuels. If you use an oxygenated fuel, be sure
fuels
it is unleaded and meets the minimum octane rating requirement.
Before using an oxygenated fuel, confirm the fuel's contents. Some states and
provinces require this information to be posted on the fuel pump.
The following is the Wacker Neuson approved percentage of oxygenates:
Ethanol
(Ethyl or grain alcohol) 10% by volume. You may use gasoline containing up to
10% ethanol by volume (commonly referred to as E10). Gasoline containing more
than 10% ethanol (such as E15, 0r E85) may not be used because it could damage
the engine.
If you notice any undesirable operating symptoms, try another service station, or
switch to another brand of gasoline.
Fuel system damage or performance problems resulting from the use of an
oxygenated fuel containing more than the percentages of oxygenates above are
not covered under warranty.
wpm_tx001560gb.fm
20
Operation
Advertisement
Table of Contents
