Table of Contents
Advertisement
7
Commissioning
7.1
Tests before commissioning
7.2
Safety instructions for operation
[en] | 02/2020 | 5100056064 | VP | Operator's manual
Information
Further information and detailed descriptions,
page 31
.
Perform the following checks:
• Check machine and components for damage.
– Do not put the damaged machine into operation. Damages and
defects must be repaired immediately.
• Check fuel level.
• Check fuel lines for leaks.
• Check air filter.
• Check engine oil level.
• Check reversing starter.
WARNING
Tipping hazard due to slipping or overturning machine!
At least 2/3 of the machine must be on a stable surface near edges.
► Take the machine out of operation and lift it back onto a stable sur-
face.
Operation on inclined surfaces
NOTICE
Technical damage due to failure of engine lubrication!
► Do not exceed the maximum permissible inclination, see
nical data on page 42
• Only approach gradients from below.
Ground conditions
The maximum dumping height depends on several factors of the ground
conditions. An exact specification of this value is not possible.
▪
Determine the maximum fill height by compaction tests or soil
samples.
Shaking in cobblestones
▪
To avoid damage to the machine or compaction material, use a slid-
ing device,
see Accessories on page 41
Tests before commissioning 7.1
see Maintenance on
.
.
Commissioning
see Tech-
27
7
Advertisement
Table of Contents
