uAvionix AV-30-C Installation Manual page 36

Label
UNIT FUNCTION
FUNCTION LOCK
[AI]
PITCH TRIM
[AI]
ROLL TRIM
[AI]
SLIP TRIM
[AI]
OAT TRIM
[AI]
IAS TRIM
[AI]
ALT TRIM
IAS UNITS [AI]
[AI]
IAS VSO
[AI]
IAS VS1
[AI]
IAS VFE
[AI]
IAS VNO
[AI]
IAS VNE
IAS VMC [AI]
[AI]
IAS VYSE
[AI]
BARO UNITS
[AI]
TEMP UNITS
GPS NAV SRC
SERIAL 2
SERIAL 3
AID MODE
VIBE MONITOR
GYRO CAL
MAG CAL
DEMO MODE
SW PART NUM
SW VERSION
SW CHECKSUM
SW CERT
[AI]
Available when Install Menu accessed through AI mode only
* Initial factory value
UAV-1003947-001, AV-30-C, Installation Manual
Rev E
Table 7 - Installation Menu Setting
Description
Unit functionality
Functionality Lock
Pitch trim
Roll trim
Slip trim
OAT probe trim
IAS trim
Barometric altitude trim
IAS display units
Stalling speed in landing
configuration
Stalling speed in a specific
configuration
Maximum flap extended speed
Maximum structural cruising speed
Never exceed speed
Minimum control airspeed with the
critical engine inoperative
Speed for best rate of climb OEI
(single engine)
Altimeter barometric units
OAT units
Serial GPS format
Reserved
Reserved
AHRS aiding mode
Vibration monitor
Calibrates aircraft gyros
Calibrates internal magnetometer
Demo mode
Software part number
Software version
Software checksum
Software certification
Values
Set to default mode: AI* or DG
If locked, pilot may not change unit function
Trim as needed: ±20 Degrees (0*)
Trim as needed: ±5 Degrees (0*)
Trim as needed: ±5 Degrees (0*)
Trim as needed: ±200 (Unitless) (0*)
Trim as needed: ±50 KTS or MPH (0*)
Trim as needed: ±500 Feet
Knots* (KTS) or Miles Per Hour (MPH)
Set to match limits: 40 to 300 knots (50*)
Set to match limits: 40 to 300 knots (60*)
Set to match limits: 40 to 300 knots (100*)
Set to match limits: 40 to 300 knots (150*)
Set to match limits: 40 to 300 knots (175*)
Set to match limits: 40 to 300 knots or disabled*
Set to match limits: 40 to 300 knots or disabled*
Inches of Mercury* (INHG), Millibars (MB)
Celsius* (C) or Fahrenheit (F)
NONE*, AV1 9600, NMEA1 4800, NMEA1 9600,
BEACON X
NONE*
NONE*
NONE*, MAG1, MAG2 – MAGx only available for
units with magnetometer
Push to view
Perform at installation or software update
Perform in-flight calibration after installation –
only available for units with magnetometer
DISABLED*, MODE 1, MODE 2
For reference
For reference
For reference
For reference
36