Operation
➜
Switch to screen 3 in
Options:
Vacuum
–
(vacuum pressure, setting range 1 – 1,400 mbar)
Hysteresis
–
selection menu, see also section "Menu item Hysteresis Δp" on page 113)
Rotation
–
(rotation speed, setting range 10 – 280 rpm)
Heating bath
–
Chiller
–
(chiller temperature, setting range -10 – 20 °C)
➜
After entering all required values, press
➜
Assign an individual designation to the favourite.
It is not possible to assign designations for favourites twice in the
system. If a desired designation already exists, a warning message
appears on the display.
In this case, change the designation or overwrite the existing
favourite. This operation cannot be undone!
Edit favourites
➜
Load the desired favorite as described above.
➜
Switch to the parameters page (screen 3 in
from the start page of the loaded favourite on the touch panel:
➜
To edit the individual parameters, follow the steps in the previous section "" on
page 137 .
➜
Confirm all changes with
➜
Confirm the designation to store the favourite with the changed values in the
system.
Touch the
and at any level. All changes made to the ramp profile before are
discarded.
➜
Confirm the additional confirmation prompt with
Alternatively, assign an individual designation to the modified
favourite to create a new one with similar values based on the
existing one, see also section "" on page 137.
Delete favourites
➜
Open the list of favourites (see section "Load favorite" on page 137).
➜
Highlight an existing favourite. The list can contain several screens: Use the two
arrow keys to move between the list pages.
favourites
mode to define the individual parameters.
(touch the entry to open the automatic/manual hysteresis
(heating bath temperature, setting range 20 – 210 °C)
Save
. The on-screen keyboard opens.
Cancel
button to cancel the operation at any time
Save
to open the on-screen keyboard
favourites
mode): Swipe left twice
ok
to accept all changes.
138