Operation
The value
condenser temperature T(AA) and the defined intensity.
This value is displayed on the second screen after the process is
started, see figure.
➜
Go back to the home page. The following options are available:
coolant temperature
–
Touch the
temperature
to deactivate (icon changes from orange to white) the assigned process
independently of the other processes.
Warm Up
–
Touch the
bath.
Start Process
–
Touch the
setpoints at the same time.
Use the parameter
the behavior of the motor lift at process start, see section "Menu
item Start process: Lift" on page 116).
Stop Process
➜
Touch the
Use the parameter
off
start, see section ). Heating bath on = heating bath heating is not
switched off when stopping the process! See section "Menu item
Stop process: Heating bath" on page 117.
Use the parameter
define the behavior of the chiller at process start. Chiller on =
chiller is not switched off when the process is stopped! See section
"Menu item Stop process: Chiller" on page 117.
Switch point Ts
icons to activate (icon changes from white to orange) or
button to activate the heating function for the heating
button to start all processes with the displayed
Start process: Lift on/off
button to stop all ongoing processes at the same time.
Stop process: Heating bath on/
to define the behavior of the heating bath heater at process
Stop process: Chiller on/off
results from the measured
rotation
heating bath
,
and
129
to define
to