AJAX DoubleButton User Manual page 4

5. Hold any of two buttons for 7 seconds. After adding DoubleButton, its LED
will flash green once. DoubleButton will appear in the list of hub devices in
the app.
To connect DoubleButton to a hub, it should be located on the same protected object as
the system (within the hub's radio network range). If the connection fails, try again in 5
seconds.
DoubleButton can be connected to one hub only. When connected to a new hub,
the device stops sending commands to the old hub. Added to a new hub,
DoubleButton is not removed from the device list of the old hub. This must be
done manually in the Ajax app.
Updating the device statuses in the list occurs only when DoubleButton is pressed and
does not depend on the Jeweller settings.
States
The states screen contains information about the device and its current
parameters. Find the DoubleButton states in the Ajax app:
1. Go to the Devices tab
2. Select DoubleButton from the list.
Parameter
Battery charge
LED brightness
.
Battery charge level. Two states are indicated:
• ОК
• Battery low
Indicates the LED brightness level:
• Off — no indication
• Low
Value