Installation Preparation; Installation Precautions; Site Requirements; Temperature And Humidity - Tadiran Telecom Aeonix TGW SIP-PRI Series User Manual

TGWxE1 G a te w a y S e rie s U s e r M a n u a l
Item
Storage Environment
For avoidance of personal injury and device damage, please read this chapter carefully before installation.

2.1 Installation Precautions

For your safety, please follow the precautions when TGWXE1 is installed and used.
Keep the site far from the heat and humidity

Take precautions with use of high-voltage electricity

Please let the experienced or trained operator to install and maintain TGWXE1

Wear static discharge wrist strap

Ensure the proper electric ground of installed equipment

Properly connect the power cable to TGWXE1

Do not plug the power cable when in use

UPS is advised


2.2 Site Requirements

2.2.1 Temperature and Humidity

Check the temperature and humidity of equipment room. To ensure the normal operation and long service
life of the gateway, the temperature and humidity in the room should be kept at the proper range.
The humidity in the equipment room should be kept between 10% and 90% (non-condensing). Abnormal
humidity condition may cause problems to the gateway:
Long term high humidity may lead to bad insulation and even cause electricity leakage, mechanical

property change and corrosion.
Low humidity is likely to leave captive screws to loose due to static electricity built up and the

insulation washer shrunk.
The temperature in the equipment room should be kept between 0℃ and 40℃. Abnormal temperature
condition may cause problems to the gateway:
High temperature acceralets aging of electrical parts and insulation materials.

Low temperature, however, may destabilize the operation of gateway.

2 -6
Description
-10 to 60℃, Non-Condensing Humidity 10 to 95%
2

Installation Preparation

Ta d ira n Te le c o m