Temperature Sensor Removal/Replacement
To remove the temperature sensor located in the hood collar, follow these steps:
1.
Disconnect the temperature sensor from the terminal block located in the Capture
Jet
®
for the correct terminations points.
2.
Unscrew the tightening collar on the temperature sensor.
3.
Remove the temperature probe.
4.
Replace the defective temperature probe with a replacement (Halton Part # 17641)
5.
Reconnect wiring.
M.A.R.V.E.L. Installation Operation & Maintenance Manual
hood. Refer to the terminal block diagram on the Halton-supplied wiring diagram
2. Unscrew collar
20