Halton M.A.R.V.E.L. Operator's Manual page 22

DIP Switch
To terminal block in control
7 . Replace with a replacement actuator (Halton Part # 16012). Tighten the U-bolt on the
drive shaft.
8. Reset the DIP switches.
Reset the stop screws.
9.
10. Reconnect the power.
11. Calibrate the new actuator by pressing the
close.
M.A.R.V.E.L. Installation Operation & Maintenance Manual
box
Reset button. The dampers will open and
22
Tighten U-bolt