Replacement Part Numbers; Preventative Maintenance - Halton Capture Jet KVE-WW Operator's Manual

With water wash technology

Hide thumbs Also See for Capture Jet KVE-WW:

Table of Contents

REPLACEMENT PARTS SCHEMATIC

Replacement Part Numbers

KSA Grease Extractor

LED Light Base

LED Light Lens

Water Wash Nozzle Information

Two different nozzles are supplied with the Capture Jet Water Wash Hood. Replacement nozzles are obtained from

Spraying Systems Co. Catalog number B5 nozzle washes the top of the grease plenum, the back of the KSA filters, the

front of the KSA grease filter, and make up a portion of the nozzles in the wash manifold that washes the inside of the

KSA grease filter. The B5 nozzles have an inlet connection size of 1/8" , orifice diameter 0.031" . The balance of the nozzles

which wash the inside of the KSA grease filter are Catalog number C30. The C30 nozzles have an inlet connection size of

1/8" , orifice diameter 0.023" . Maximum recommended water pressure is 80 psi, typical water pressure would be 40 psi.

Preventative maintenance is necessary for efficient operation of your Capture Jet ™ Water Wash hood.

Daily - Clean exhaust hood exterior. See cleaning exterior. Run the hood wash cycle.

Monthly - Inspect filters for grease accumulation and clean if required. Although this is listed as monthly, it may be

extended or shortened depending on the type of cooking and hours of operation.

Capture Jet

with Water Wash Operation & Maintenance Manual

13" X 20" – KSA13, 13" X 11" – KSA13-1/2

10982

10848 Warm White 24 LEDs

10849 Cool White 24 LEDs

10979 Warm White 12 LEDs

Table of Contents

Capture jet kvc-ww