Iris™ Sensor Removal/Replacement - Halton M.A.R.V.E.L. Operator's Manual

IRIS™ Sensor Removal/Replacement
To remove the IRIS™ Sensor, follow these steps:
1. Disconnect the IRIS™ sensor from the terminal block located in the Capture Jet
hood. Refer to the terminal block diagram on the Halton-supplied wiring diagram for
the correct terminations points.
2. Remove the face plate of the sensor by removing the 4 face plate screws.
3. Lift out the face plate and sensor and gently pull out the sensor wires.
4. Remove the sensor bracket from the face plate by removing the 2 screws on the
faceplate.
5. Remove the sensor from the sensor bracket by removing the 3 screws.
6. Reverse the steps when replacing the IRIS™ sensor (Halton Part # 18037).
2. Remove 4 faceplate screws
M.A.R.V.E.L. Installation Operation & Maintenance Manual
4. Remove 2 screws from
faceplate
4. Remove 3 screws from
mounting bracket
19
®