System Installation; Mount The Central Control Panel (For Multiple Units With A Single Fan) - Halton M.A.R.V.E.L. Operator's Manual

M.A.R.V.E.L. System Installation
The following installation steps ONLY apply to the M.A.R.V.E.L. components
(IRIS™ Sensor, MC8 Control Panel, Pressure Transducer and Temperature Sensor).
Refer to the Capture Jet
Refer to the Halton engineering drawings for additional details.
Refer to the Halton wiring drawings for confi guration details.
Refer to the fan manufacturer's manual for detailed instructions on the fan installation.
It is the responsibility of the installing contractor to see that the system installation is complet-
ed in accordance with the project plans and specifi cations and that it meets all specifi c require-
ments of local code offi cials. The local authority having jurisdiction could over rule some of the
installation details written in this manual.
The installation shall be in accordance with NFPA-96. All electrical systems shall be installed fol-
lowing local and national codes.
If questions or complications should arise during the installation of the Halton hood (s) that
cannot be solved using the instructions provided, please contact the Halton offi ce at 1-800-442-
5866, or (1-800-4-HALTON).
If a problem cannot be correct through verbal or written communication with Halton support,
the system can be connected to the Internet for remote access to Halton engineers through
the KONTAR-Konsole™ Commissioning and Diagnostic Software Interface.
If the site doesn't have reasonable access to the Internet, a wireless CDMA router can be
shipped by Halton to the facility for temporary (or permanent) access.
Check all local codes prior to installation as special requirements may be necessary depending
on local building material construction.

1. Mount the central control panel (for multiple units with a single fan)

NOTE: For all units, there is a pre-mounted control panel on the top of the hood.
1. The central control panel is supplied with mounting tabs that extend from the back wall up and
down and provide at least four points of attachment. The appropriate mounting hardware is to
be used depending on the unit size and the type of wall to be attached to.
2. Locate the central control panel at an appropriate mounting height (e.g., access to the control
in the front door of the panel).
3. Attach the central control panel using the four mounting holes:
• For concrete block walls, solid block and brick surfaces: Use sleeve stud anchors
(recommended).
Example:3/8 " dia.- thread:5/16-18; washer OD:7/8 "( Drill size 3/8 ")
• For Plaster, Wallboard and Plywood: Use sleeve screw anchors( drive or drill style)
(recommended).
M.A.R.V.E.L. Installation Operation & Maintenance Manual
® Hood IO&M Manual for complete details on installation of the hoods.
11