Sony RM-NX7000 Operating Instructions Manual page 50

Continued
Programming a preset code using the list of component
preset codes (SEARCH)
The following steps are continued from step 4 on page 44.
Programming a preset code of a TV component is explained here.
1 Press the [SEARCH] key in
the programming method
selection display.
Instructions for the preparation of the
component to be registered appear in the
display. Set the component to the status
as instructed.
Press the [OK] key.
2
The list of preset codes appears in the
display. Make sure that the first preset
code is selected by the cursor.
Press the [v] or [V] key to
3
select a component preset
code by the cursor, aim the
Remote Commander at the
component to be registered,
and then press the [TEST]
key.
The Remote Commander transmits the
remote control signal. One test key signal
is assigned to a preset code. The name of
test key signal is displayed on the left of
the [TEST] key.
z Tip
Each time you press the [v] or [V] key, the cursor moves one line up or down on
the list. If you press the [v] or [V] key for 2 seconds or longer, the list in the
display scrolls.
50
Programming the preset codes of components (PRESET)