Sony RM-NX7000 Operating Instructions Manual page 45

When programming of a preset code is complete
The display returns to the Component key selection display (step 3, page 43).
To program another component successively
Repeat the procedure from step 3 on page 43.
To perform other settings after finishing the setting of
programming a preset code
Press the [EXIT] key. The display returns to the previous mode display.
To finish all settings
Press the COMMANDER OFF button for 2 seconds or longer. The display
returns to the Home display. Or press the [EXIT] key repeatedly until the Home
display is shown.
Confirming whether the correct preset code is programmed
Operate the component using the Remote Commander. For details on operation,
see "Operating a component (Operation mode)" (page 37).
Programming a preset code using the remote control of a
component (SOLUTION)
The following steps are a continued from step 4 on page 44.
Place the Remote Commander head to head with the remote control of the
component to be registered to. While programming, do not disconnect or
connect the USB cable or the AC power adaptor, or do not remove or insert a
"Memory Stick", as a malfunction may result.
Programming a preset code of a TV component is explained here.
Press the [SOLUTION] key in
1
the programming method
selection display.
Instructions appear in the display and
the Remote Commander is set to the
standby mode for receiving the remote
control signal.
To cancel the standby mode
Press the COMMANDER OFF button.
The display returns to the programming method selection display.
Continued
45