Sony RM-NX7000 Operating Instructions Manual page 26

Continued
Installing "NAVITUS Design"
Follow the instructions below to install.
Notes
• Do not copy the "NAVITUS Design" folder in the supplied CD-ROM to a computer.
• On Windows 2000 Professional, or Windows XP, logon with the ID authorized as the
computer administrator when installing "NAVITUS Design."
1
Close all software running on Windows.
2
Insert the supplied CD-ROM in the CD-ROM drive of the computer.
After a moment, "InstallShield Wizard" of "NAVITUS Design" appears.
3
Click [Next].
Follow the on-screen instructions and proceed with the installation.
The "InstallShield Wizard Complete" display appears when the installation
is complete.
z Tip
If the installation display is hidden behind other windows
"InstallShield Wizard" of "NAVITUS Design" may be sometimes hidden behind
other displays while the installation is in progress and you cannot operate the
installation. In this case, press the [Tab] key several times while pressing down the
[Alt] key. "InstallShield Wizard" of "NAVITUS Design" appears again.
4
Click [Finish].
The message telling you to restart the computer appears.
5
Click [OK].
The computer restarts, and installing of "NAVITUS Design" finishes.
After restarting the computer, install consecutively the USB driver.
Before installing the USB driver, confirm the operating system of your
computer, and then perform the procedure from step 4 in "Installing the
USB driver" that begins from the next page.
26
Setting up the Remote Commander using "NAVITUS Design"