Sony RM-NX7000 Operating Instructions Manual page 125

5
Press the key/button whose macro
you want to check.
The macro procedure programmed in "Step
2" is shown in the display in order.
When a function key is programmed as a
step, the key appears where the key is
assigned in the display. When a function
button is programmed, its name appears in
the center of the display.
When showing is complete, the display
returns to the first page of the selected
component.
Notes
• A function key for which no macro is programmed appear pressed and cannot be
selected. If you select a function button for which no macro is programmed, a
message appear.
• The macro procedures of the [JUMP] key and the [DELAY] key are not displayed.
To manually check the programmed macro procedure in order
Press the [PAUSE] key to suspend consecutive showing. Press the [PAUSE]
key again to resume consecutive showing.
While consecutive showing is suspended, press the NEXT button to show
the next macro step and press the BACK button to show the previous step.
6
To finish all settings, press the COMMANDER OFF button for 2
seconds or longer.
The display returns to the Home display. Or press the [EXIT] key repeatedly
until the Home display is shown.
To check the settings of the component macro (Component key and
Direct Access button)
1
Press the [SET] key for 2 seconds or longer in the Home display.
The Set display appears.
2
Press the [HOME EDIT] key.
The Home Edit display appears.
Continued
125