Table of Contents
Advertisement
4. Parameter Configuration
4.1. Communication Parameter Concept
4.1.1. Communication Category Concept
The communication parameters for SS-HQ1 are divided into the 24 categories shown below.
Communication categories are divided into separate segments for each control target, so that the byte
positions of the individual parameters are easy to remember.
4.1.2. Communication Category Details
Category number
CAT1
CAT2
CAT3
CAT4
CAT5
CAT6
CAT7
CAT8
CAT9
CAT10
CAT11
CAT12
CAT13
CAT14
CAT15
CAT16
CAT17
CAT18
CAT19
CAT20
CAT21
CAT22
CAT23
CAT24
CAT24 (TEST) is an undisclosed parameter for testing purpose.
CAT20 is a port driver control setting parameter, while CAT12-19, CAT-22, and CAT-23 are firmware control
parameters of the built-in CPU.
CAT1-11 are hardware parameters. Note however, that care is necessary because even if the values of
parameters for controlling port drivers (CAT20) and firmware (CAT12-19) are set directly by external
communication, they will be overwritten by port drivers or the firmware. To directly control these parameters for
control using external microcomputer and so on, port driver controls are required to be reset and firmware to be
stopped (HOLD processing).
(For details of list of parameters for firmware control and the setting method, refer to "13.3 Tables: The
parameters controlled by FW".)
Do not change MODESEL and SGMODE control parameters because they are controlled by firmware.
Table 4.1-1 Serial Communication Classification Table
Category name
SYSCON
Parameters related to general setting of system
PICT1
Image quality setting parameters 1
AE1
Parameters related to AE 1
AWB1
Parameters related to AWB 1
OPDWIND1
Parameters related to OPD window 1
TG
Parameters related to TG
EXTSYNC1
Parameters related to external synchronization 1
FEADJ(EVRI)
Parameters related to built-in EVR
MASKPG
Parameters related to mask function and PG
DIF
Parameters related to digital interface
BLMDETS1
Parameters related to blemish detection and compensation 1
CPU
Built-in controller setting and operation mode setting
PICT2
Image quality setting parameters2
AE2
Parameters related to AE 2
AWB2
Parameters related to AWB 2
OPDWIND2
Parameters related to OPD window 2
EXTSYNC2
Parameters related to external synchronization 2
FEADJ(EVREXT) Parameters related to external EVR
PREADJ
Parameters related to line adjustment
PORT
Port driver setting parameters
BLMDET2
Parameters related to blemish detection and compensation 2
SOUT1
Serial output setting parameters 1
SOUT2
Serial output setting parameters 2
TEST
Parameters related to LSI
Description
31
- SS-HQ1 Application Notes -
Ver.1.0.0 January 7, 2005
Advertisement
Table of Contents
