11.3. Adjustment of TG Phase
You can adjust phase and drive ability of high frequency TG pulse (H1, H2, RG, XSHP, XSHD, XRS). You can
acquire a suitable CCD signal by adjusting phase and drive ability, and it can be well sampled. Since these
phases may change with the composition of a substrate, or methods of wiring, please adjust a phase if
needed.
11.3.1. Adjustment method of phase and drive ability
Adjustment of delay
Delay can be changed by the parameter of Table 11.3-1. Moreover, as shown in Table 11.3-2, a setting value
is changed, and the amount of delay can be adjusted. Please refer to Fig 11.3-1about the situation of change.
DEH1
DEH2
DERG
DESHP
DESHD
DERS
* The values shown in table are rough data. These values are not guaranteed.
Table 11.3-1 Adjusting parameter of delay
Parameter
CAT6_Byte9_bit0-3
CAT6_Byte9_bit4-7
CAT6_Byte10_bit0-3
CAT6_Byte10_bit4-7
CAT6_Byte11_bit0-3
CAT6_Byte11_bit4-7
Table 11.3-2 Amount of delay adjustment
Setting Value
adjustment (ns)
0[h]
1[h]
2[h]
3[h]
4[h]
5[h]
6[h]
7[h]
8[h]
9[h]
A[h]
B[h]
C[h]
D[h]
E[h]
F[h]
174
- SS-HQ1 Application Notes -
Description
Adjustment of H1delay
Adjustment of H2delay
Adjustment of RG delay
Adjustment of XSHP delay
Adjustment of XSHD delay
Adjustment of XRS delay
Amount of
0
+1
+2
+3
+4
+5
+6
+7
-8
-7
-6
-5
-4
-3
-2
-1
Ver.1.0.0 January 7, 2005