Sony SS-HW1 Operating Instructions

Speaker System
Operating Instructions
Mode d'emploi
사용설명서
SS-HW1
English
Features
WD (Wide Dispersion) super tweeters on the
front and top provide a multidirectional
listening experience. That way, high-quality
sound from sound sources or CDs can be
enjoyed in wider area than with conventional
speakers.
Attaching speaker pads
Attach the supplied speaker pads to the
bottom of the speakers to prevent slipping.
Connections
Before connecting, turn off the amplifier to
ˎ ˎ
avoid damaging the speaker system.
When turning the amplifier or program
ˎ ˎ
source power on/off, reduce the sound level
on the amplifier to minimum.
When bass sound is missing or the sound
ˎ ˎ
output position of musical instruments is
not distinct, make sure the +/– terminals of
speaker cords are connected properly.
Precautions
Avoid driving the speaker system
ˎ ˎ
continuously with a wattage exceeding the
maximum input power of each speaker.
Do not place anything on the speakers.
ˎ ˎ
Connection/Raccordement/
4-534-167-21(1)
Right
Droit
오른쪽
Speaker cord (supplied)
Cordon d'enceinte (fourni)
스피커 코드(부속품)
Output power of your receiver or amplifier must not be over the maximum input power of
ˎ ˎ
the speaker system, and an appropriate volume level to prevent sound distortion must be
kept. See "Specifications" for the maximum input power.
La puissance de sortie de votre récepteur ou de votre amplificateur ne pas doit être
ˎ ˎ
supérieure à la puissance d'entrée maximum du système d'enceintes, et vous devez
maintenir le volume à un niveau approprié afin d'éviter la distorsion. Voir la section
« Spécifications » pour connaître la puissance d'entrée maximum.
리시버 또는 앰프의 출력이 스피커 시스템의 최대 입력을 초과하면 안되며, 적정 음량을 유지해서

사운드가 왜곡되지 않게 해야 합니다. 최대 입력은 "사양"을 참조하십시오.
© 2014 Sony Corporation
Do not attempt to open the enclosure or
ˎ ˎ
remove speaker units. There are no
user-serviceable parts inside.
Keep recorded tapes, watches, personal credit
ˎ ˎ
cards, and hard disk drives using magnetic
coding away from the speaker system.
The speaker system has been tuned without
ˎ ˎ
the grille on. Remove the grille before using
the speaker system.
Cleaning and maintenance
To avoid damaging the enclosure, do not
ˎ ˎ
use thinner, alcohol, benzene, etc.
To keep a good gloss on the enclosure, dust
ˎ ˎ
it first using a soft cloth, a brush, or a feather
duster and then polish it using a dry
cleaning cloth (never use a scrubbing brush
or a sponge).
Wipe the surface gently. For fingerprints or
ˎ ˎ
oil stains, etc., breathe on the surface and
wipe it off with a cleaning cloth.
If the enclosure becomes extremely dirty,
ˎ ˎ
wipe the enclosure using a soft cloth slightly
moistened with a soap and water mix.
Be careful not to scratch the surface of the
ˎ ˎ
enclosure.
Wipe dust and other dirt from the WD (Wide
ˎ ˎ
Dispersion) super tweeter (top panel) using
a blower brush or soft brush.
Speaker Placement
Please note that room acoustics can often
ˎ ˎ
produce large difference in the sound for
small changes in speaker placement.
Place the speaker system against a hard
ē ˎ
wall with its back about 20 cm away from
a wall.
Place the right and left speakers in a
ē ˎ
similar acoustic environment.
– terminal (black)
Borne – (noire)
- 단자(검은색)
+ terminal (red)
Borne + (rouge)
+ 단자(빨간색)
Printed in China
연결
Amplifier
Amplificateur
앰프
Speaker cord (supplied)
Cordon d'enceinte (fourni)
스피커 코드(부속품)
Do not place the speaker system in the
ˎ ˎ
following places:
Anywhere that is extremely hot or under
ē ˎ
direct sunlight
Anywhere that is dusty
ē ˎ
Anywhere that is extremely humid
ē ˎ
Near a player
ē ˎ
In a cabinet, especially one above your line
ē ˎ
of sight
About the 13 cm woofer cone
Black spots on the woofer cone surface occur
naturally in the mica used for the cone
material. They do not affect the sound/
characteristics of the speaker.
Specifications
Speaker system 3 way, 4 drivers speaker
system
Loud speaker units Woofer: 13 cm, cone type (1)
Tweeter: 2.5 cm, soft dome
type (1)
Super tweeter: 1.9 cm, soft
dome type (2)
Enclosure type Bass reflex
Rated impedance 4 ohms
Maximum input power 100 watts
Sensitivity level 83 dB (2.83 V, 1 m)
Effective Frequency Range 50 Hz - 50 kHz
Dimensions (w/h/d) Approx. 171 mm × 309 mm ×
273 mm
Mass Approx. 5.1 kg
Supplied accessories Speaker cords (2)
Speaker pads (8)
Operating Instructions (1)
Design and specifications are subject to change
without notice.
Left
Gauche
왼쪽