ADEEPT PiCar-Pro Manual page 55

2.3 What is a web controller
The web controller is a web interface used to control the robot products to
perform various actions. It can be used on PCs, mobile phones, tablets, and any device
that can run a browser.
If you install the contents of the software package according to the document, it is
very simple to open the web controller.
1. Make sure your device is in the same local area network as the Raspberry Pi.
2. Obtain the IP address of the Raspberry Pi (refer to the software installation
section).
3. Open the browser on the device (chrome browser is recommended to avoid
possible browser compatibility issues), enter the IP address of your Raspberry Pi in
the address bar, and visit port 5000, for example: 192.168.3.44 :5000
The web controller will then be loaded into the browser.
Depending on the product, the modules on the web controller are also different.
Below is a list of most of the modules and their usage. You can compare the modules
52