ADEEPT PiCar-Pro Manual page 52

Table of Contents

Advertisement

1.8 Installing the dependency library of PiCar Pro
program
We have prepared a script to install all the dependent libraries that need to be
used and set up operations such as turning on the camera and automatically running
on startup.
Steps:
1. Enter the following code in the console and run the script setup.py to install
the required dependent libraries:
sudo python3 adeept_picarpro/setup.py
2. Press Enter to confirm. The following operations are automatically completed
by the script program. Depending on the network environment, this process may last
for tens of minutes or several hours, just wait patiently.
3. After the installation is complete, the console will show text:
After the installation is complete, the Raspberry Pi will automatically disconnect
the SSH connection and restart. At this time, if you are using a Raspberry Pi
connected by software such as Putty, there will be an error message such as Network
error: Software caused connection abort, which is normal, just close the window.
49

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PiCar-Pro and is the answer not in the manual?

Table of Contents

Save PDF