Table of Contents
Advertisement
The robot arm after assembly is as shown in the figure above.
9.4.3 PTZ installation
note:
1. When installing the servo, the gear of the servo should be in the middle of the servo
rotation range.
2. After installing the software in the Raspberry Pi, the Raspberry Pi will
automatically run the robot product program when the Raspberry Pi is turned on.
After powering on the servo, the drive board will automatically place the servo in the
middle position.
122
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PiCar-Pro and is the answer not in the manual?