ADEEPT PiCar-Pro Manual page 131

9.4.4 Body installation
note:
1. When installing the rocker arm of the servo, the gear of it should be in the middle
of the rotation range of the servo, and then install the servo as shown in the figure
below.
2. After installing the software in the Raspberry Pi, the Raspberry Pi will
automatically run the robot product program when the Raspberry Pi is turned on.
After powering on the servo, the drive board will automatically place the servo in the
middle position.
Use M3*4 screws to fix the "L" type aluminum alloy on the servo, install the rocker
arm, fix it with M3*4 screws, and use M3*10 screws to pass through the rocker arm.
(Due to the issue of the production version of the servo, if the M3*4 screw cannot fix
the rocker arm, please use the M3*10 screw to fix it)
128