ADEEPT PiCar-Pro Manual page 104

supports power supply below 15V.
9. When installing the servo rocker arm in the structure assembly, you can use
the USB cable to power the RobotHAT. After the Raspberry Pi with the robot
software installed, it will control the RobotHAT to set all the servo ports to output
neutral signals. You can connect the servo to any servo port, the gear of the servo will
turn to the neutral position, and then you can install the servo rocker arm according to
the specified angle. After the rocker arm is installed, you can disconnect the servo and
RobotHAT. When you need to install the rocker arm of the second servo, connect the
second servo to any servo port on the drive board.
9.4 Assembly
9.4.1 Screw color description
101