Running Belt Alignment And Tracking Adjustment - Precor Precision 400 Series Service Manual

b. At this point the tension pressure has increased significantly and care must be
taken to not damage the adjustment hardware and/or belt. The tension gauge
will be used to determine when to alternate the left and right bolt tension adjust-
ment rather than the alternating 1/4 turn bolt method. Alternately adjust the left
and right side tension in increments of 0.2 (0.2%) gauge divisions until the man-
ufacturer tension specification is reached.
Running belt tension
Notes: * Referenced to gauge reading 3.0 (0.0%)
10. Remove the tension gauges.
11. Verify the running belt alignment and tracking, continue with the
ment and tracking adjustment"

Running belt alignment and tracking adjustment

What is a centered and properly tracking running belt
A properly centered belt does not mean that the belt is perfectly centered on the deck and
rollers. It is a belt that tracks steady and does not touch or rub the landing trim or any other
frame or hardware parts. Always attempt to position the belt as close as possible to the cen-
ter of the deck and rollers.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Running Belt
below.
5 Adjustment Procedures
Running Belt Tension and Tracking Adjustment
Specification
3.55 (0.55%)*
"Running belt align-
Page 55