Precor Precision 400 Series Service Manual page 25

1. Access the Hardware Validation service menu (51765761) and perform the fol-
lowing tests, see
Select Test to start the test and Stop Test to exit.
Display GUI/Metric Tests
l
Key Test
l
Heart Rate Test
l
Belt Speed Test
l
Incline Test
l
2. Exit the Hardware Validation Diagnostic Test menu (press the Home softkey).
Machine Operation Test
This test verifies the console functionality (motion controls & metric indicators) and
machine operation.
SPEED control test:
1. Do this test while walking on the machine and the INCLINE set to 0% incline.
2. Select QUICKSTART to begin a manual workout.
3. Operate the SPEED motion control from minimum to maximum range while veri-
fying the machine operation.
Make sure that the console SPEED paddle control operation is smooth
l
and working correctly.
Verify that the running belt can reach the maximum speed and then
l
returns to the minimum speed level.
Make sure that the running belt speed change is smooth and that there are
l
1
analog to digital converter
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Standard Service Menus" on
Backlight brightness changes.
o
Numerals cycle properly.
o
Keys all function.
o
Heart rate is acquired and displayed.
o
Running belt moves and is controlled from 0.5 mph to 12.0 mph in
o
0.1 increments.
Use the incline controls to raise/lower incline to verify the following
o
1
incline angle A/D
Nominal A/D value: 13 ±5 @ -2% incline.
n
NominalA/D value: 37 ±5 @0% incline.
n
Nominal A/D value: 242 ±5 @ 15% incline.
n
page 36.
values:
3 Operation Verification
R40 Operation Verification Test
Page 18