Lift Motor Replacement; Videos; Procedure - Precor Precision 400 Series Service Manual

Lift Motor Replacement

This procedure provides instruction to remove and replace the Lift Motor.

Videos

TRM400 Lift Motor Replacement

Procedure

Review entire procedure before starting.
Note: The replacement lift motor must be calibrated prior to installation.
1. If not already set to 0% incline, set the incline to 0%.
2. Switch the treadmill power "OFF" and
3. Disconnect the lift motor cable connectors from
4. Remove the lift motor's green frame ground wire from the frame.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
2
Lower Printed Circuit Assembly board; also refered to as the Lower PCA or simply as the
lower board. On treadmills, it is the console to base function interface and the motor con-
troller unit (MCU). On self-powered units, it is the lower PCA console to base function inter-
face.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Service Video
unplug
6 Replacement Procedures
Lift Motor Replacement
LIft Motor Replacement
1
the power cord.
2
LPCA J1 and J7 connectors.
Link
Page 80