Adjust The Running Belt Tracking - Precor Experience Series 700 Line Assembly Manual

Adjust the running belt tracking

1. Start the treadmill and set the speed to 3 MPH (5 KPH).
2. Observe the running belt tracking while verifying that the belt remains
centered:
If...
Then turn the right side roller mounting bolt ...
If the belt starts to
slowly and manually turn the right side take-up roller
drift toward the
mounting bolt clockwise (Figure 13) in quarter-turn
right
increments until the drifting stops.
If the belt starts to
slowly and manually turn the right side take-up roller
drift toward the left
mounting bolt counter-clockwise in quarter turn
increments until the drifting stops.
3. Increase the speed to 9 MPH (14 KPH) and then 12 MPH (19 KPH), making any
small adjustments as needed.
Important During this functional test, if there is noticeable hesitation of the running belt
with each foot plant, check the Running Belt Tension procedure in the Maintenance Guide
that came in your treadmill box or on our website at www. precor.com.
Figure 25
Notes
The tracking adjustments should only be done in quarter turn increments.
•
ONLY use the right side take-up roller mounting bolt to adjust tracking.
•
ONLY use hand tools to adjust tracking.
•
12