Precor Precision 400 Series Service Manual page 30

Verify the running belt condition
1. Visually Inspect the belt condition; no surface rips, tears, or frayed edges. Also
check the seam for damage.
INSPECTING THE RUNNING BELT CONDITION
Verify the running belt alignment and tracking.
1. Step off the running belt and operate the treadmill at 12 mph (19 kph) for one
minute.
2. Verify the running belt alignment and tracking remains centered.
RUNNING BELT ALIGNMENT AND TRACKING PROCEDURE
ESTOP Switch Test
Verify the ESTOP emergency stop switch operation.
1. While walking on the treadmill, press the emergency STOP button and verify
that the running belt immediately slows to a stop.
2. While walking on the treadmill, pull the ESTOP lanyard and make sure the run-
ning belt immediately slows to a stop.
3. Inspect the condition of the ESTOP lanyard clip, that the spring is in place and
that the clip will firmly hold when attached to the runner.
4. Make sure that the clip is properly stowed and not wrapped around the handle-
bars.
Heart Rate Monitor Test
Verify the Handheld Handlebar Heart Rate
1. Access the Hardware Validation Test (51765761) and do the Heart Rate Test.
Return to service
1. Verify that there are no new error codes.
2. Switch the power OFF.
3. Make sure that the machine is setting level and stable.
machine leveling procedure
4. Make sure that any external power cords or interface cables are properly
routed, connected, and safe from being damaged.
5. On successful completion of all verification tests, return to service.
1
Handheld Handlebar Heart Rate
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
R20 Operation Verification Test
1
(HHHR ) function.
3 Operation Verification
Page 23