Precor Precision 400 Series Service Manual page 29

Stop Key Test
l
2. Exit the Hardware Validation Diagnostic Test menu (press the Home softkey).
Machine Operation Test
This test verifies the console functionality (motion controls & metric indicators) and
machine operation.
SPEED control test:
1. Do this test while walking on the machine and the INCLINE set to 0% incline.
2. Select GO to begin a manual workout.
3. Operate the SPEED motion control from minimum to maximum range while
verifying the machine operation.
Make sure that the console SPEED paddle control operation is smooth
l
and working correctly.
Verify that the running belt can reach the maximum speed and then
l
returns to the minimum speed level.
Make sure that the running belt speed change is smooth and that there
l
are no unusual noises.
Verify that the console SPEED indicators and workout metric displays
l
are showing correct information.
INCLINE control test
4. Set the SPEED between 2-3 mph and walk on the belt while performing this
test.
5. Operate the INCLINE motion controls from minimum to maximum range while
verifying the machine operation.
Make sure that the console INCLINE paddle control operation is smooth
l
and working correctly.
Verify that the running deck can reach the +15% maximum incline and
l
then return to the -2% minimum incline level.
Verify that the lift motor operation is smooth while changing the INCLINE
l
from minimum to maximum levels.
Verify that the console INCLINE level indicators and user workout dis-
l
plays are showing correct information.
Running Belt Operational Test
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
cifications.TRM40014-R20Incline0%]]]
Nominal A/D value: 200 ±5 @ 15% incline
n
Tests the STOP button (press STOP to test) and lanyard ESTOP
o
functions (pull the lanyard to test ESTOP). Pressing Workouts will
exit the Stop Key test.
3 Operation Verification
R20 Operation Verification Test
Page 22