Table of Contents
Advertisement
from the front of the vehicle to warn nearby
pedestrians that a vehicle is approaching.
In addition, the module will indicate
change in speed by varying the pitch of
sound.
LOW (L)
This range should be used when descending
very steep grades. The vehicle transmission
can be operated continuously in LOW without
damaging the vehicle or causing issues.
Using the LOW position will increase the rate
of deceleration (along with increasing regen-
eration of power into the vehicle's high
voltage battery) when the accelerator pedal is
released in comparison to the DRIVE posi-
tion. To access the LOW position, push down
on the gear selector and rotate it fully clock-
wise. Shifting between DRIVE and LOW can
be done at any speed.
NOTE:
Driving the vehicle in Low will make the
transitions between vehicle accelerating
and coasting, as well as, vehicle coasting
and accelerating more noticeable.
Based on the drive gear and/or speed of the
vehicle, the Quiet Vehicle Pedestrian
Module (QVPM) will broadcast a sound
from the front of the vehicle to warn nearby
pedestrians that a vehicle is approaching.
In addition, the module will indicate
change in speed by varying the pitch and/
or volume of sound.
Transmission Limp Home Mode
Transmission function is monitored electron-
ically for abnormal conditions. If a condition
is detected that could result in transmission
damage, Transmission Limp Home Mode is
activated. In this mode, vehicle speed is
limited to about 45 mph (72 km/h). In addi-
tion to the Malfunction Indicator Light (MIL),
the Service Hybrid System Telltale, the Red
Turtle indication, and a popup message indi-
cating that vehicle speed may be limited may
all be illuminated. Limp Home Mode allows
the vehicle to be driven to an authorized
dealer for service without damaging the
transmission.
In the event of a momentary problem, the
transmission can be reset to regain function-
ality by performing the following steps:
1. Stop the vehicle in a safe location.
2. Shift the transmission into PARK, if
possible. If not, shift the transmission to
NEUTRAL.
3. Push and hold the ignition switch until
the vehicle turns OFF.
4. Wait approximately 30 seconds.
5. Restart the vehicle.
6. Shift into the desired gear range. If the
problem is no longer detected, the trans-
mission will return to normal operation.
NOTE:
Even if the transmission can be reset, we
recommend that you visit an authorized
dealer at your earliest possible convenience.
An authorized dealer has diagnostic equip-
ment to assess the condition of your trans-
mission. If the transmission cannot be reset,
authorized dealer service is required.
69
Advertisement
Table of Contents
