Table of Contents
Advertisement
Maintain
Exhaust
System
Temperature (after engine start in current
ignition cycle - emissions requirement)
Engine Temporarily Operating in "Fuel and
Oil Maintenance Mode"
Hood Opened with Ignition in Run
Post-Start Mode (eliminate unexpected
engine start-ups)
In case the ignition switch does not change
with the push of the button, the key fob may
have a low or depleted battery. In this situa-
tion, a back up method can be used to operate
the ignition switch. Put the nose side (side
opposite of the emergency key) of the key fob
against the START/STOP ignition button and
push to operate the ignition switch.
Keyless Push Button Ignition
20
Catalyst
WARNING!
When leaving the vehicle, always remove
the key fob from the vehicle and lock
your vehicle.
Never leave children alone in a vehicle,
or with access to an unlocked vehicle.
Allowing children to be in a vehicle unat-
tended is dangerous for a number of
reasons. A child or others could be seri-
ously or fatally injured. Children should
be warned not to touch the parking
brake, brake pedal or the gear selector.
Do not leave the key fob in or near the
vehicle, or in a location accessible to
children, and do not leave the ignition of
a
vehicle
equipped
Enter-N-Go in the RUN mode. A child
could operate power windows, other
controls, or move the vehicle.
Do not leave children or animals inside
parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
An unlocked vehicle is an invitation.
Always turn the vehicle off, remove the key
fobs from the vehicle, and lock all the
doors when leaving the vehicle unattended.
NOTE:
If the brake is pressed and the ignition is
placed in the RUN position with an EVSE
connected to the vehicle, the instrument
cluster display will not display the READY
state. When the Electric Vehicle Supply
Equipment (EVSE) is unplugged from the
vehicle, the vehicle will go into the READY
state. If the vehicle is not shifted out of
PARK 30 minutes after being unplugged, the
with
Keyless
vehicle will disable the READY state. After an
additional 30 minutes with no change in
ignition status, the ignition will turn off and
the vehicle will power down. Refer to
"Starting The Vehicle" in "Starting And Oper-
ating" for further information.
CAUTION!
Advertisement
Table of Contents
