Table of Contents
Advertisement
Indicator Light (MIL) is functioning and is
not on when the engine is running, and that
the OBD II system is ready for testing.
Normally, the OBD II system will be ready.
The OBD II system may not be ready if your
vehicle was recently serviced, recently had a
depleted battery or a battery replacement. If
the OBD II system should be determined not
ready for the I/M test, your vehicle may fail
the test.
Your vehicle has a simple ignition actuated
test, which you can use prior to going to the
test station. To check if your vehicle's OBD II
system is ready, you must do the following:
1. Cycle the ignition switch to the ON posi-
tion, but do not crank or start the engine.
NOTE:
If you crank or start the engine, you will have
to start this test over.
2. As soon as you cycle the ignition switch to
the ON position, you will see the
"Malfunction
Indicator
symbol come on as part of a normal bulb
check.
3. Approximately 15 seconds later, one of
two things will happen:
The MIL will flash for about 10
seconds and then return to being fully
illuminated until you turn OFF the igni-
tion or start the engine. This means
that your vehicle's OBD II system is not
ready and you should not proceed to
the I/M station.
The MIL will not flash at all and will
remain fully illuminated until you
place the ignition in the off position or
start the engine. This means that your
vehicle's OBD II system is ready and
you can proceed to the I/M station.
If your OBD II system is not ready, you should
see an authorized dealer or repair facility. If
Light
(MIL)"
your vehicle was recently serviced or had a
battery failure or replacement, you may need
to do nothing more than drive your vehicle as
you normally would in order for your OBD II
system to update. A recheck with the above
test routine may then indicate that the
system is now ready.
Regardless of whether your vehicle's OBD II
system is ready or not, if the MIL is illumi-
nated during normal vehicle operation you
should have your vehicle serviced before
going to the I/M station. The I/M station can
fail your vehicle because the MIL is on with
the engine running.
49
Advertisement
Table of Contents
