Table of Contents
Advertisement
3. If the charging cordset is ready to charge,
ensure the vehicle is in PARK, and then
connect the charge connector to the
vehicle's charge inlet. You will hear a
"click" when the charge connector is
inserted correctly and coupled with the
vehicle's charge inlet.
Inserting The Charge Connector Into The
Vehicle Charge Inlet
4. When the vehicle commences charging,
the Charge Active Indicator Lights on the
EVSE will cycle from left to right, and
then both turn off. This pattern will
repeat while the vehicle is charging. The
lights are illuminated at the rate of
approximately one cycle per second.
NOTE:
The vehicle should start charging automati-
cally. If not, please check the following:
Charging Cordset — The charging
cordset status indicators illuminate
green or red to identify the charging
cordset status. Refer to "Trouble-
shooting Using The Status Indicator
Display" in this section for further infor-
mation on the charging cordset status.
Wall Receptacle — Check whether the
wall receptacle is functional (no power
outage) and/or plug the charging
cordset into a different wall receptacle.
Charging Schedule — Check whether or
not the charging schedules have been
enabled. If enabled, check that you are
within the scheduled time and day of the
week. If a charging schedule has been
enabled in the vehicle, and it is outside
the time and day of the week, you may
override the schedule for this charging
event
by
plugging
in
connector, unplugging it, and then plug-
ging it back into the vehicle charge inlet.
Complete the double plug sequence
within 10 seconds for it to override the
set schedule.
Hood Ajar — Check whether the hood
is open. Charging is disabled while the
hood is open, and will resume when the
hood closes.
5. To stop the charging process, disconnect
the vehicle side connector first and then
the charging cordset from the wall recep-
tacle. To disengage the vehicle coupler,
push the button on the charge connector
first and then remove the connector from
the vehicle charge inlet.
the
charge
Removing The Charge Connector From The
Vehicle Charge Inlet
6. Close the inlet door when an EVSE is not
connected to the vehicle.
9
Advertisement
Table of Contents
