Remote Switch Signal Connector; At/Atx Sw; Led; Installation - JHCTech KMDA-2602 User Manual

Table of Contents

2.4.14 Remote Switch signal Connector

For the remote switch signal interface of the switch machine, the terminal of the motherboard coastline is

a 2-pin terminal, as shown below.

The KMDA-2602 provides a AT/ATX SW, which users can set Power-on mode by it. When you dial it at

AT, it means power on by AC Power; When you dial it at ATX, it means power on by Power button.

There are 1*Power on LED, 1*HDD Run LED, 3*CPU temperature class LEDS on the front. CPU

temperature class LED(Green(≤85℃)/Yellow(≥86℃and≤95℃)/Red(≥96℃). Users can monitor the

working state of the CPU according to the display of the LED.

Step 1.Unscrew 6 screws on the left/right side.

Step 2.Unscrew 6 serial copper columns on the front panel.

Step 3.Unscrew the spring pad and nut of the DC-IN on the front panel.

Step 4.remove the front panel.

Step 5.Put the HDD/SSD in the drive bay screw 4 screws.

Step 6.Pull the drive bay onto the bottom cover.

Step 7.Screw 4 screws on the drive bay with the bottom cover.

Step 8.Using the SATA cable connect the SATA drive and SATA power/data connector of mother board.

Figure 2.25

Table 2.13: Remote Switch Pin Assignments

Pin\Type

Signal

PWR_BTN

GND

User's Manual

Table of Contents