JHCTech KMDA-2602 User Manual page 39

Step 4.Screw one screw to the holder as shown in the picture.
Step 5.Install the subcard on the motherboard .
Screw 4 screws on the subcard.
Install the rear panel.
Screw 2 screws on the left/right side.
Screw 1 screw and 10 serial copper columns on the rear panel.
Connect the SATA cable which connected the SATA drive and the SATA power/data connector of
mother board.
Close the bottom cover back to the chassis, screw 2 screws on the left/right side.
Install the front panel.
Screw 4 screws on the left/right side.
Screw 6 serial copper columns on the front rear, lock the nut and spring pad of the DC-IN on the
front rear.
Figure 2.47
Figure 2.48
32
User's Manual